Scrub your floor with the tsp.
Concrete floor prep for stain.
How to clean and etch a concrete surface step 1.
Use a rotary scrubbing machine with a special pad designed.
Sweep your concrete floor with a shop broom gathering up as much dirt and debris as possible.
Apply the product directly on stained areas for best results.
Sweep and mop to remove all dust dirt and debris as these will show through the stain and can impact the finished look.
This video shows the steps that must be taken in preparation for staining concrete floors.
Buy some trisodium phosphate tsp.
The most important step of how to stain a concrete floor is surface preparation.
Prep the surface grinding the surface while it may not be standard practice for all staining contractors is a requirement for hyde concrete.
New concrete should be at least four weeks old.
If you are wanting to prep concrete floor for staining you can use a 30 grit satellite pad that is diluted super blue for deep cleaning.
And rinse well a couple of times with clean water.
Using a floor scraper pull up as much of the.
The crew grinds every slab they stain even if it s a new pour.
With an htc 500 floor grinder and a few hand held angle grinders hyde concrete will open up the floor usually to about the 150 grit level.
So let s dive into the prep process for removing any contaminants and marks on your concrete flooring.
If he must remove glue mastic or paint from the floor he uses nonflammable chemical strippers which he finds at home depot lowes or sherwin williams.
Use the product at full strength for tough stains.
Begin by removing all items from the floor and cleaning the area thoroughly.
This will help you figure.
Apply the stain prep and let it sit for 5 minutes 30 minutes if you are removing heavy areas of grease oils or tire marks and then scrub the area with a stiff straw brush or a rented floor buffing machine with the aggressive scrubbing stripping pads.
Tips on how to stain concrete floors.
If the floor still looks stained or patchy hire a floor grinder to grind away a thin layer from the surface of the concrete.
This includes removing carpe.
Give the area a final clean with t s p.
For scrubbing he recommends using a rotary floor scrubber with a green nylo grit pad designed for aggressive scrubbing of concrete.
This will remove the most stubborn remnants of most penetrating stains like oil and grease.
If your previously coated surface is in good condition you may coat over it.
Start by spraying your concrete floor with a gentle spritz of water.