Tie the string to the downspout then stretch it out and around all the stakes.
Connect 2 underground gutter lines.
And the wire insulation 5 8 in.
Snap the downspout tube into the main drain line.
Something that can be very damaging to the foundation of a home is exterior water.
Others have vertical pipes that either connect to a drain or run directly into the ground itself.
Run the tape measure from the bottom of the lower elbow to the ground and add 1 1 2 inches for the top joint where it connects to the.
Some houses use downspouts that direct the flow of water downhill or down a slanted driveway.
Buried or underground roof drainage downspout defects clogging overflowing holes corrosion leaks that cause wet basements or crawl areas proper installation of buried downspout extensions proper installation of french drains seepage pits at flat sites gutter downspout defects cause wet basements crawl areas questions answers about installing maintaining repairing buried roof.
Cut the cable about 12 in.
The process to install underground gutter drainage to move water away from the foundation of a home also known as a french drain.
Use a collar or connector if necessary to secure the extender to the downspout and lock it in place.
On either side of the break.
Slip the sock over the connection.
Make sure that the connection between the downspout and the extender is snug and secure.
Use a string and 1x2 stakes to lay out the trench.
Use two special underground splice kits sold at home centers to connect the new cable section.
But i laid out my pvc pipe and fittings into their approximate shape cut pipe to the necessary length and used purple primer and pvc glue to connect the pvc parts.
Wipe pvc glue using its applicator around the outside.
Once the tubing is in place cover it with at least 3 in.
Then strip back the sheathing 2 in.
In this latter case the water then travels away from the home through one or more underground drain pipes.
Pound in two stakes 4 feet from the house and directly in front of each downspout.
A gutter s purpose is to move water from a roof to the desired location but usually this is right by the foundation of a home.
Connect the black ribbed hose or rigid downspout extender to the existing downspout to the gutters.
Allow for about 1 1 2 inches of overlap at each connection.
Slide the heat shrink tube over one end of the cable then connect the wires to the brass connector photo 1.
Place other stakes spaced 8 feet apart in between.