Cooper Motion Sensor Light Switch Instructions

The lights will turn off 5 seconds after motion is no longer detected.

Cooper motion sensor light switch instructions.

Match up screw holes on the cover plate with the junction. Rotating the light adjustment knob will control at what level of brightness the motion sensor will turn the light on when it is in automatic mode not test mode. Turn the light switch to the off position for 40 seconds and then turn back to the on position. Motion is detected the lights will turn on.

In either mode the. Press and hold the on off button for 10 seconds until the indicator led blinks for the second time the led will also blink at the 5 second point. Select a location that is 6 to 8 feet above ground level. Make sure the sensor is not picking up moving objects such as trees traffic etc.

Turn off power at the main fuse or breaker box. Install your fixture near a doorway or pathway to. The sensor green wire will connect to the ground wire in the wallbox. The sensor red wire will connect to the wire which goes to the light fixture.

Turn the power back on at the circuit breaker. Turn the light control knob all the way clockwise to the moon symbol dusk position fig. Instructions for a cooper outdoor motion detector location. Install the sensor loosely using the mounting screws provided.

Repeat this procedure to restore normal operation. Apply power and wait one minute. When unit stabilizes about 1 minute the sensor is ready to detect motion. Automatically release the button while the led is blinking.

Unit is in override mode if there is no motion. The sensor blue wire is not used and should be capped off with a wire nut. Switch or in the unlikely event of a failure of the motion sensor. There is motion in the detection zone.

Reposition the sensor. Two locations one location is the sensor and the other location is a standard 3 way switch two locations replace both 3 way switches with sensors in automatic on mode the lights turn on automatically when a person enters the room.